| 摘 要： |
Rills are primary sediment sources and hillslope water/sediment runoff transport channels. Water flow velocities in rills are easily affected by bed condition over eroding and non-eroding slopes, which is an important hydrodynamic process in soil erosion research. This research is done to demonstrate the poorly understood feedback mechanism related to slope independence of flow velocity to slope gradient. A series of experiments were done on silt loam soil slopes to measure water flow velocity in rills under nine unit width flow rates (q) (0.17 x 10-3, 0.33 x 10-3, 0.67 x 10-3, 1.33 x 10-3, 2.67 x 10-3, 5.33 x 10-3,10.67 x 10-3, 21.33 x 10-3, and 42.67 x 10-3 m3/(s$m)) combined with four slope gradients (8.7%, 17.6%, 26.8%, and 36.4%), in which mobile bed rills were monitored. For unit flow velocity under q < 1.33 x 10-3 m2/s, independence of flow velocity to slope was obtained. However, the results indicated that slope gradient combined with a higher unit flow rate contributed to better velocity prediction and fitted with a segmented equation well (R2 = 0.95). A feedback mechanism was able to verify that the increase in roughness directly dissipated flow energy to reduce flow velocity, but cannot completely counterbalances steep slope effect. The experimental results showed that erosion-caused morphological changes on soil slopes reduce flow velocity by half due to an increase in bed rough-ness. Therefore, the current experimental measurements considering a wide range of flow rate and slope gradient conditions is useful to reveal the steep slope effect in mobile bed rills. The analysis showed that, for the investigated conditions, the flow velocity is a slope gradient-and flow rate -dependent parameter.(c) 2022 International Research and Training Centre on Erosion and Sedimentation/the World Association for Sedimentation and Erosion Research. Published by Elsevier B.V. All rights reserved. |
在线留言
联系我们
所长信箱